Skip to main content
Table of Contents

Verizon Configuration Guide

Update the configuration on your device to work on the Verizon network after installing the upgraded communication board.

Travis Bates
Updated by Travis Bates

Update the configuration on your device to work on the Verizon network after installing the upgraded communication board or installing a Verizon SIM card.

Swap the module

Follow the board replacement instructions to swap the module:

ZL6 Instructions

ATMOS 41W Instructions

Update the device configuration

Use the Module Swap Wizard in ZENTRA Utility Mobile to update the settings in your device. If you do not have access to ZENTRA Utility Mobile, follow the manual steps below in the terminal in ZENTRA Utility for desktop.

Terminal Commands (Manual)

Requirements:

  • The correct module. See Module Identification.
  • SIM card number starting with 8914.
  • Firmware version 2.09 or later.

Steps:

  1. Connect
    1. Connect via a cabled connection (Desktop).
  2. Terminal
    1. Click Terminal in the Menu bar to open the terminal window.
  3. Set the Access Point Name or APN
    1. Type set apn vzwinternet and press enter.
    2. The response in the terminal should be "OK".
    3. Type get apn to verify the setting has been updated.
    4. The response in the terminal should be "vzwinternet".
  4. Set the Profile
    1. Type set profile 3 and press enter.
    2. The response in the terminal should be "OK".
    3. Type get profile to verify the setting has been updated.
    4. The response in the terminal should be "3".
  5. Test
    1. Disconnect the logger from ZENTRA Utility and then re-connect.
    2. Run a communication test to verify connectivity with the network.

How did we do?

AT&T / T-Mobile Configuration Guide

Worldwide H1 SIM Configuration Guide

Contact