ZL6 Antenna Extension

Updated by Travis Bates

This article details how to install an antenna extension for the ZL6 data logger.

Steps

  1. Remove the four screws that hold the circuit board to the case.

  1. Carefully flip the circuit over to access the back of the board where the cable attaches.

  1. Detach the cable from the cellular module where the connection pivots by pulling straight out.

  1. Detached cable.

  1. Snap the extension connector in place.

  1. Run the cable out under the board through the cable exit for port 2 or port 3. Replace the 4 screws to re-secure the circuit board.

How did we do?